Advaero Technologies

HVARTM PDF Print E-mail

Our unique process takes VARTM to a new level by using heat at a relatively low temperature, followed by curing “out of autoclave” at room temperature on the mold. The cure time is typically 3-5 hours, depending upon the resin used. The typical fiber/volume fraction obtained is 60-65% or more, depending upon the weave of the material, resin used and other factors.

 

Ask about our work in NanoFibers

 

Advaero has pioneered the use of high temperature nanofibers in composite materials. These lightweight, high performance nanofibers significantly increase composite strength and improve resistance to impact.